What do I need to run more boost
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Sep 2005
Location: The yorkshire dales - best roads in the UK
Posts: 3,311
Likes: 0
Received 0 Likes
on
0 Posts
What do I need to run more boost
I am swapping from an Apexi ecu and an Apexi boost controller to a Simtek ecu that uses the standard map senser. Before I was running just under 1.4 bar, am I right in saying the standard map senser will only go to 1.25.
What do I need to be able to run the boost as before, car is 93 type RA.
What do I need to be able to run the boost as before, car is 93 type RA.
#4
Scooby Regular
Join Date: Apr 2007
Location: East Sussex - www.polarperformance.co.uk
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
standard map sensor on Pre96 only allows you to run about 1.15bar boost with fuel cut set at 1.25bar (approx).
you may be able to run with a Post96 Map sensor if the simtek can be rescaled with the required values/cal data.
Is the simtek available to anyone to fit now ? or is it limitted to Harvey/Steve Simpson ?
you may be able to run with a Post96 Map sensor if the simtek can be rescaled with the required values/cal data.
Is the simtek available to anyone to fit now ? or is it limitted to Harvey/Steve Simpson ?
#5
SimTek can be configured to run any MAP sensor.Favourites would be 97-98 Subaru or Delco 3 bar.Your installer can advise.
Dealers currently are:
Interpro, Bristol
Alan Jeffery Engineering, Plymouth
Triton, Bournemouth
ScoobyMania, Nottingham
Simpson motorsport, Lancaster
Steve
Dealers currently are:
Interpro, Bristol
Alan Jeffery Engineering, Plymouth
Triton, Bournemouth
ScoobyMania, Nottingham
Simpson motorsport, Lancaster
Steve
Trending Topics
#8
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Sep 2005
Location: The yorkshire dales - best roads in the UK
Posts: 3,311
Likes: 0
Received 0 Likes
on
0 Posts
standard map sensor on Pre96 only allows you to run about 1.15bar boost with fuel cut set at 1.25bar (approx).
you may be able to run with a Post96 Map sensor if the simtek can be rescaled with the required values/cal data.
Is the simtek available to anyone to fit now ? or is it limitted to Harvey/Steve Simpson ?
you may be able to run with a Post96 Map sensor if the simtek can be rescaled with the required values/cal data.
Is the simtek available to anyone to fit now ? or is it limitted to Harvey/Steve Simpson ?
Just steve I think.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
hedgecutter
General Technical
3
25 September 2015 02:35 PM