25rsti

Hi all!


Was trying to find out if a GC8 exhaust system will fit my Bugeye GD?


I've searched multiple forums and have seen many people install GD exhaust into their GC but not vice versa.


Thank you.

Infected by sti

iTrader: (6)

Yes it will but you will need a full exhaust inc the downpipe.

There is one hanger on the back you can't utilise iirc unless you have it turned.

25rsti

What's different with the downpipe? JDM/AUDM vs USDM length?

Infected by sti

iTrader: (6)

Not sure on that fella sorry, there are posts on here regarding the lengths if you dig about.

jaygsi

iTrader: (46)

Right so you have a new age impreza turbo and you want to know if a classic turbo exhaust system will fit?

25rsti

Yes.

I actually just purchased it. It will take some time to get to me but can update with what I find out.

This is one of my bugs.
IMG_9988 by D.Brough, on Flickr

jaygsi

iTrader: (46)

Right then yes, a classic system will fit your bugeye impreza, the down pipe is longer i think on the newage so you would need a complete system of a classic, from down pipe to back box.

Also another thing to keep in mind is the lambda sensor hole in the down pipe is in a different location on the classic, on the newage i think its further down, but i think it will still reach. Also some systems have 2 holes so can be run on either cars

25rsti

Thank you very much for the info.

I may be wrong but I thought for some reason the piping coming out the muffler might bend differently between classic and newage?

I won't really know until I get it and compare to mine though. :crossing my fingers:

25rsti

I got the exhaust in. I still need to a comparison to see what's actually different.

bludgod

iTrader: (3)

I've got a classic system on mine. the length difference is in the downpipe and the center section. The hangers as mentioned above you can heat and bend it round to match

The classic has a shorter downpipe/longer center section - presumably due to less cats.

jura11

iTrader: (7)

Hi there

As above GC8 exhaust will fit GD just hangers are not in correct place,but they will fit,if you want to do it right then I would reweld them to correct place,we are run several classic(GC8) exhausts on our wagon(GGA/GD) without the issue,just as above you will need too center pipe and downpipe

Hope this helps

Thanks,Jura

25rsti

So I layed the ARC exhaust next to my Fujitsubo Rmo1a and the ARC is a few inches longer.

Because it is titanium I will have a shop cut my downpipe to accommodate the exhaust.

It seemed that the hangers were in the correct places though.

bludgod

iTrader: (3)

aye its the backbox hangers that are in the wrong place, the two end ones are okay either said of the tailpipe - the one further back on the exhaust pipe before the backbox needs switched from one side to the other.

Guardian-X-

iTrader: (1)

Sorry for digging this thread back up from the dead but i think it's better to post here than open a whole new thread.

Does anyone know if GD Prodrive muffler (just the backbox) fits a GC8? I know the rear hanger of the backbox is pointed the other way but i'm talking pipe diameter and length of the exhaust.

Anyone here have this setup? (standard GC8 exhaust with just a GD prodrive backbox?)