Hi. Does anybody know if lauch control can be fitted to a standard ecu. Thanks

 

Hi there

Its possible to have enabled on OEM(standard) ECU,but this depends if its New age or classic

Jura

 

Its a new age 2003 blobeye. Cheers

 

Yes you can, switchable maps, anti lag and flat shifting too if you fancy it.

 

Sounds good. But i think i might just stick with lauch control for the time being. How much am i lookin to get it installed. Thanks

 

can u get all the above on ecutek maps

 

You can contact any EcuTek or OS(Open Source) mapper/dealer which can map this without the problem,prices are various

EcuTek is more expensive route and Open Source is less expensive(in some cases cost twice less than EcuTek mapping)

Speak to here mappers like Simon@JGM,MartnJ@ET,Paul@Zen or Open source mappers like Duncan@Race Dynamix or Andrew Carr

Jura

 

Bob rawle in Swindon he's good.

 

Alcatel ecu have both launch and anti lag work very well,the new Alcatel has flat floor shifting as well. Plus has the option of toocan display .

 

I was under the impression these mods aka racerom are only available if you have fly-by throttle and delta dash, i.e hawkeye and hatches i maybe wrong

 

i have them on my 05 sti done by andrew carr

 

had launch on my 51plate bug wrx too from mr carr

 

Do you get the auto bilp and dual maps aswell?

 

my blob sti has been mapped by dunc dynamix on open source and has launch control mapped in.

i can 100% confirm this as i just tried it, i didnt even know it was there.

on my car you have to be going below 10 kmh and just plant the throttle and it revs to 5k and sits there until you dump the clutch.