ready for remap were to go?
#1
Scooby Regular
Thread Starter
ready for remap were to go?
Hey guys! I have a 2006 wrx hawkeye. After buying the car stock.. the mods so far are
Turbo back exhaust x2 cats gone. .
Front mount intercooler
K@n cone filter
Aps fuel pump
Iv had to disconnect the maff sensor for the car to run.. and dont really want to drive to long with it in this way.
Any ideas were to go im from south wales dont mind travelling just want a good job done. Would really want anti lag also ... power figures u think i could get to ?
Thanks guys!
Turbo back exhaust x2 cats gone. .
Front mount intercooler
K@n cone filter
Aps fuel pump
Iv had to disconnect the maff sensor for the car to run.. and dont really want to drive to long with it in this way.
Any ideas were to go im from south wales dont mind travelling just want a good job done. Would really want anti lag also ... power figures u think i could get to ?
Thanks guys!
#3
Scooby Regular
iTrader: (2)
Join Date: May 2010
Location: Brecon, Mid Wales
Posts: 1,909
Likes: 0
Received 0 Likes
on
0 Posts
Hi smithy,
Re-post this thread in the welsh section mate, youll probably get a bit more feedback.
Im 99% Simon (Jolly Green Monster) is coming up thursday this week to Indigo Gt (tredegar) to do some mapping/rr runs, also Anthony at Indigo Gt is a well respected mapper around here.
Id be very careful running the car with MAF unplugged, drive it very carefully and low revs!!
Atb
Re-post this thread in the welsh section mate, youll probably get a bit more feedback.
Im 99% Simon (Jolly Green Monster) is coming up thursday this week to Indigo Gt (tredegar) to do some mapping/rr runs, also Anthony at Indigo Gt is a well respected mapper around here.
Id be very careful running the car with MAF unplugged, drive it very carefully and low revs!!
Atb
Thread
Thread Starter
Forum
Replies
Last Post
Wingnuttzz
Member's Gallery
30
26 April 2022 11:15 PM