VDC and Si drive problem
Thread Starter
Scooby Newbie
Joined: Jan 2018
Posts: 12
Likes: 0
From: high peak
VDC and Si drive problem
Hope someone can help me out with a problem I have with my 08 Impreza hatch sti
Every few weeks or so I get the Si drive flashing S and this then comes up with P0852 code neutral switch high circuit, I have now just changed the switch for a brand new genuine part and within a day the same as happened??
Also I don't know if the problem is linked or not but I cannot turn off the traction control, I have tried a single press and holding it down for 1 2 10 seconds and nothing.. the traction control light comes on when ignition is turned on the goes off after 1 second or so. I have tried a new switch but still the same. Even when the P0852 code is cleared and the Si drive works as it should the traction control VDC does nothing when pressed.
Any help much appricated cheers
Every few weeks or so I get the Si drive flashing S and this then comes up with P0852 code neutral switch high circuit, I have now just changed the switch for a brand new genuine part and within a day the same as happened??
Also I don't know if the problem is linked or not but I cannot turn off the traction control, I have tried a single press and holding it down for 1 2 10 seconds and nothing.. the traction control light comes on when ignition is turned on the goes off after 1 second or so. I have tried a new switch but still the same. Even when the P0852 code is cleared and the Si drive works as it should the traction control VDC does nothing when pressed.
Any help much appricated cheers
Thread
Thread Starter
Forum
Replies
Last Post
dr jim
ScoobyNet General
2
Jun 21, 2012 10:01 PM