i've just seen that the fuel pressure regulator pipe has been cut on my 96 wrx. the is about 1" of rubber hose coming from the reg but i can't find where it should go to. can someone please tell me where it should go to.

thanks

 

Just taken this pic of a spare inlet I have, the FPR fixes where the open end is and the red line is the vacuum hose route.
It goes onto that metal pipe which comes back out near the throttle, where a rubber hose connects it to one of the vacuum feeds at the top.

 

The hose you speek of sounds like the vacuum which goes from the FPR to the inlet manifold. dont know what year it is so i cant tell you were on the inlet manifold.

 

top man, i've just fitted a new pipe to it. i would never of found it without the pic.

cheers

 

No worries, I had the Very same problem.

Just make sure the other end is attached.
If you look at the inlet manifold you`ll see 3 vacuum feeds before you get to the throttle. The pipe on the same side as the throttle position sensor (opp side to accelerator cable), will be a black vacuum hose going down to a metal pipe which goes under the inlet manifold, this is the other end of that metal pipe. Pointless making sure the it on at the FPR if the other side is off too.

 

is one of the 3 feeds for the dump valve?

 

Yeah as you look at the front.
Left large one is the dump valve and Boost Gauge.
Middle one is Boost Control Solenoid.
Right one is for the Fuel pressure regulator.

 

thanks again, yes its connected the strange thing is it was running fine with the FPR pipe missing, i thought it would run like a bag of nails with it off?

 

Lord knows, see what its like now.

 

i've taken it for a little spin, it seams the same as before

at least i know its connected now