crank pulley torque ?
Guest
Posts: n/a
crank pulley torque ?
im about to change my crank pulley for a nice new colourfull item. what torque should i do the bolt up to ? this video says 90 ftlb. that seems a bit low for me ?
any ideas?
dan
http://videos.hspn.com/?videoid=65&catid=1
any ideas?
dan
http://videos.hspn.com/?videoid=65&catid=1
Scooby Regular
Joined: Jan 2006
Posts: 3,695
Likes: 0
Nice new colourful item? You mean a genuine Subaru bolt or an aftermarket one of some sort?
Assuming a genuine bolt, the correct installation sequence is to oil the thread lightly, tighten to 44Nm, and then make a further angular tighten between 65 and 75 degrees.
On a used bolt, the tightening sequence is first to 44Nm, and then to 180Nm, checking that the bolt has rotated at least 65 degrees between the two points. If less than 65, throw and replace.
Assuming a genuine bolt, the correct installation sequence is to oil the thread lightly, tighten to 44Nm, and then make a further angular tighten between 65 and 75 degrees.
On a used bolt, the tightening sequence is first to 44Nm, and then to 180Nm, checking that the bolt has rotated at least 65 degrees between the two points. If less than 65, throw and replace.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
