OK I've now had enough......I have 2 replacement PIAA bulbs but for the life of me can't seem to get the bloody lenses off my driving lights to fit them. You can all take the pi55 if you want....I don't care just someone help me PLEASE !!!!!!!

Shark if you read this can I bring it in on Saturday and ask one of your guys to do it for me????? I'll buy you a beer.

Mike

 

Pull the lights forward and then loosen the 2 cross head screws either side and gently pry the lens out.

Darren.

 

I was looking at this with Mike when he first picked up his bulbs on Saturday - the lamps don't seem to lean forward far enough to give access to the screw nearest the centre of the car - no way we could get a screwdriver to it that I could see without removing a load of paint from the front bumper.... What are we doing wrong ?

 

They are accessible but they it is tight. The lights will move up and down fairly easily which may help access.

Oh you will need a bit of sellotape to hold the screw retaining clips in place once the light is apart. when you tighten them back up remember to make sure the light is tight into the metal back cup other wise water will get in. The best way if it is damp etc is to turn the lights on for a couple of minutes after you've replaced the bulbs whilst they are out of the back cups. Once they've cooled down a bit pop them back in!

Good luck

 

Mike

Pop in anytime and we will fit them for you.

David

 

Told you so Mike

 

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:<HR>Originally posted by Shark:
<B>Mike

Pop in anytime and we will fit them for you.

David[/quote]

Cheers Dave your a star.

Thanks for the help guys. OH and Matt....F**K YOU

 

Heh !!! !!! LOL !!!