Lucky enough to have got 3 Defi gauges for crimbo (oil temp/pressure and boost) have no problems with fitting the oil ones, however does anyone have a picture of the 3 way joint fitted between the surge tank and the fuel regulator for the boost gauge on a 95 Jap import classic.Fairly new to this and not entirely sure where all the bits are located in the engine bay.Or is there a pic with all major parts indicated on it kicking about.

 

Can you not just tee into any vacuum pipe coming off the inlet manifold?

 

Can I?

Was just following what it said in the manual, but if it can be done this way, thats fine,like i said not too sure where everything is under the bonnet, so stupid question comming in- where is the vacuum hose?

 

Also have a look
Gauges

 

Just take Tee from the manifold mate..

It will be fine

 

Cheers for that , a lot clearer now, will have a look tomorrow if not too hung over