Quickshift Fitting
25 October 2005, 10:49 AM
#1
25 October 2005, 09:55 PM
#2
Scooby Regular
Join Date: Dec 2001
Location: Just far enough from sunny Liverpool
Posts: 6,963
Likes: 0
Received 0 Likes
on
0 Posts
yep, dead easy. undo the connection to the old gear linkange, and pull the stick over to an angle until it pops out of the socket.
put the new one in, and using a block of wood and a mallet 'encourage' the new balljoint in to its socket, then bolt it all together again.
whilst you may worry about causing any damage it is very unlikely, and you do need to use a fair bit of force, but you should have the job complete in less than about 10 minutes.
put the new one in, and using a block of wood and a mallet 'encourage' the new balljoint in to its socket, then bolt it all together again.
whilst you may worry about causing any damage it is very unlikely, and you do need to use a fair bit of force, but you should have the job complete in less than about 10 minutes.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM