Are my injectors 380cc or 440cc and what is maximum bhp on these?

I have the following mods and am aiming at around 350 bhp after the conversion of my TD05 to front entry, can anyone suggest what else i need to buy including injectors to achieve this figure?

1995 WRX 260ps with
Blitz Iridium Plugs
HKS Superflow Induction kit
HKS Front Mounted Intercooler
Blitz Dump Valve
TD05 Turbo
Walbro 255 lt/hr fuel pump
FSE Uprated Fuel Pressure Regulator
Apexi Full Stainless System from turbo back
Apexi AVCR Boost Controller
VOS Chip remapped to run 1.25 bar on 95 Ron fuel

 

You def have 380 injectors.

I would say 440's and a remap should see 350 @ circa 1.4bar

But I stand to be corrected

I do have a set of 440's for sale (£110 delivered), but there for Phase 2 Rails.

So you'd need either a set of adaptors or a modified Phase 2 rail? I also have a standard Phase 2 rail around somewhere (£20 delivered) but dont know how you'd modify it.


Mike

 

So i think i would need to change the chip for an Apexi Power FC to be able to run 1.4 bar.

Think i will go 550cc as might wanna go higher than 350 bhp eventually if the 440's cant cope.

Do you know the max bhp on 440cc and 550cc injectors and how to work out?

 

iirc 440 max out around the 350ish mark where as 550 should be ok for 400ish

Again I stand to be corrected.

There is a formulae to work out the fuel flow, but I cant remember what it is. If you do a quick search you should be able to find it. I think it was One of the big boys (oo-eerr) that posted it ie D Wallis, Pavlo, Scott T, Andy F etc

Mike