Hi to all,

Need help here. just got hold of a TD05H....
I want to know what's the spec of the TD05H found on the pre 97 scooby?

I have the part no. 49178-06310 on the compressor housing. Is it a 14B; 14G or a 16G small?

keet

 

16g small (assuming its a scoob one) iirc

[Edited by David_Wallis - 5/23/2003 4:27:21 PM]

 

Thanks!

During the time i posted till you replied, really hunt thr the net for some tell tale clues...

Found this...on www.vfaq.com
"How to tell a 14B from a 16G: both the 14B and 16G have TD05H cast into the compressor housing. So how do you tell them apart? Pull the MAF hose off of the turbo, and look at the blades of the compressor wheel. The 14B has all of the blades at the same level, while the 16G alternates high/low"
AND
"16Gs normally have a 7cm turbine housing, while 14Bs have a 6cm housing. Now since there are so many custom turbos out there, you can't just assume you have a 16G if the turbine housing is a 7cm, as there are custom 6cm 16Gs out there. However, you can at least tell the various turbine housings apart - 6cm housings have 060 cast in them, 7cm have 070, and 8cm have 080 cast in them. The 8cm housing is not a normal stock housing, but Forced Performance and other DSM vendors have started ordering them from Japan, so you can now bolt one on a 14B/16G/20G hybrid for higher topend flow without clipping the turbine wheel."

My blades are alternate apart and found 070 on the turbine housing.