Hi,
What´s the thread on the bolt that´s located just below where the hose from the crankcase vent enters the intake duct?
I´m planning, if possible, to use this entry to connect to an oiltemp.gauge
BTW is it wise/possible to use this entry for this purpose?
regards
Roger-Sweden

 

Don't recall the thread off the top of my head, but the easiest thing to do is to get another oil pressure sensor boss. The thread in the block is the same at the front where the oil pressure switch is located and at the back where you plan to mount your oil temp sender. I think the oil pressure sensor has something like a 1/8 BSP thread, so you'de need an oil temp one with similar thread.

Hope this helps,

Pat.

 

Roger,

See my reply on 22b.

Adam

 

Thanks guys!