Wiring needed for JDM HID's into blobeye
#31
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jan 2010
Posts: 893
Likes: 0
Received 0 Likes
on
0 Posts
not having much luck so far, cant seem to find anywhere that's supplies the correct plugs, and if I can all seem to be in American. Shame plugs/connectors don't have part numbers on them so easier to find a source for them
#32
Scooby Regular
iTrader: (2)
How about this then:
Remove some of the insulation from behind the plug on both wires, wrap new wire round and solder, then tape up.
Lead the two new wires to a new plug, tape up the old one.
Then, when it goes back to normal, just snip off the two new wires, or tape up that plug?
Remove some of the insulation from behind the plug on both wires, wrap new wire round and solder, then tape up.
Lead the two new wires to a new plug, tape up the old one.
Then, when it goes back to normal, just snip off the two new wires, or tape up that plug?