makkink

Can any one tell me how much I have to change to mount 114.3 hubs for the bigger bearings to my sti type-r 1999.
And is it possible to juse my 5x100 wheels to these hubs.

JGlanzaV

iTrader: (3)

Lots.

New hubs and front shafts, fronts need to be machined to suit your gc suspension.

New brake discs and brackets or new calipers etc.

Its a very difficult modification hence very few people doing it

makkink

I thought the shafts and calipers would fit and yes the Hu b would get machined to fit the coilovers and I can get my ap racing bell machined to fit the hubs.
What would you think about fitting some adapter plates to fit my 5x100 wheels and disk's.

makkink

Can any one tell my if the 114.3 hubs fit a sti type-r driveshaft.

JGlanzaV

iTrader: (3)

Im led to beleive you need newage drive shafts.

makkink

I like to now for shere.
And I have ap racing calipers will these fit and the rear calipers 2pot will these also fit.
And do I have to change somting for the rear fitment.

makkink

No one.

makkink

Can any one tell me the torque strength to fasten the bearings of a 114.3 hub.
And if i can refit old bearings to the adjusted hub.

tom-r33

iTrader: (2)

Are you chewing through a lot of bearings?

There's a good thread about this on 22b forum
A guy checked the bearing dimensions and although bigger diameter turns out the ***** are the same size...
Andy Forest machined his hubs to allow for double bearings, if you did this you could retain all your old bits like bells and wheels