3" exhaust spacer @ 150mm with Flanges, Nuts, Washers and Bolts
#1
3" exhaust spacer @ 150mm with Flanges, Nuts, Washers and Bolts
Hi Guys,
I bought this for my exhaust as it was too short for what I was doing, basically the downpipe wasnt as long as it would have been if I had a complete Miltek System, so I had to space it out to make it fit snug, I placed this in position to see if was a good fit and it was spot on. However I have since sourced and fitted a matching downpipe.
So if your exhaust is 150mm / 6 inch to short then this might be what you need. It is made out of the highest grade.
This was provisional verbally sold to a guy on here, but I have since deleted my in and outbox and I forgot whom it was, sorry if thats you
Im looking for my money back at £20 Collected from here or £25 delivered.
Thanks
Rob
I bought this for my exhaust as it was too short for what I was doing, basically the downpipe wasnt as long as it would have been if I had a complete Miltek System, so I had to space it out to make it fit snug, I placed this in position to see if was a good fit and it was spot on. However I have since sourced and fitted a matching downpipe.
So if your exhaust is 150mm / 6 inch to short then this might be what you need. It is made out of the highest grade.
This was provisional verbally sold to a guy on here, but I have since deleted my in and outbox and I forgot whom it was, sorry if thats you
Im looking for my money back at £20 Collected from here or £25 delivered.
Thanks
Rob
#7
Pretty sure this is who I used, they weren't very expensive either.
http://www.jsfstainless.com/pages/co...asp?ch=address
Yes you could get it done if you bought the parts, but for hassle freeness with top quality SS and weld.....
Hope this helps.
Rob
http://www.jsfstainless.com/pages/co...asp?ch=address
Yes you could get it done if you bought the parts, but for hassle freeness with top quality SS and weld.....
Hope this helps.
Rob
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM