Head Job DIY
#1
Scooby Newbie
Thread Starter
Join Date: May 2011
Location: Johannesburg
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Head Job DIY
My 2.5 head gaskets went at 230000KM.
All the cleaning and machining is done and I am now reassembling!
A few questions:
1 Do I oil the head bolt threads?
2 Do I put copper grease on the gasket
3 Confirm that I should oil under the bolt head and washer??
4 Gaskets being purchaced from agent,is there anything better . Car gets normal/mild use . no mods and not a speedster.
We are talking about a 2002 SOHC Forrestor here regards
Geordie
All the cleaning and machining is done and I am now reassembling!
A few questions:
1 Do I oil the head bolt threads?
2 Do I put copper grease on the gasket
3 Confirm that I should oil under the bolt head and washer??
4 Gaskets being purchaced from agent,is there anything better . Car gets normal/mild use . no mods and not a speedster.
We are talking about a 2002 SOHC Forrestor here regards
Geordie
#2
Scooby Regular
iTrader: (2)
Join Date: May 2011
Location: ludlow
Posts: 212
Likes: 0
Received 0 Likes
on
0 Posts
1. a bit of grease wont hurt on them not oil
2.dont need copper grease on gasket
3.no need to oil under head bolt
4.as long as its adecent make gasket that you have heard of will be fine
2.dont need copper grease on gasket
3.no need to oil under head bolt
4.as long as its adecent make gasket that you have heard of will be fine
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM