Rob669

Anyone have any ideas why the person who did my remap would cable tie the connectors together? I want to carry out a fault finding test because I get the warning light 'Check Engine' come on every so often. Just seems a bit odd to have tied them up.

ossett2k2

iTrader: (9)

Depending what you have it mapped with?
Is it alcateck? If yes then the diagnostic ports don't work for you anymore.
If ESL then they do.

Rob669

Standard ECU remap (and carried out by Duncan sometime ago) therefore the diagnostics ports should all be as they were before. I just find it unusual that they've been tied together almost as though they shouldn't be used again.

ossett2k2

iTrader: (9)

Standard ECU remap? What year classic

Rob669

MY00 UK Turbo, road remap first then finished off on the RR at SRR. Nothing massively special, has the same TD04 and runs slightly over 280 horses.

ossett2k2

iTrader: (9)

Ah my00 will be Ecutek then most likely.
Not sure if ecutek retains oem diagnostic? Sure someone will be along to confirm.

Some ECU maps like alcatek use CEL as shift and knock light.

Rob669

OK. Cheers.

Gambit

iTrader: (6)

Are they connected, or just tied up out of the way. Tied up out of the way is how they come from factory

Rob669

Tied up, not connected so perhaps he just did it for neatness then?

I have tried asking him but never got a reply.

Cheers

bludgod

iTrader: (3)

also yes with an ECUtek map you'll retain your stock diagnostic features.

Rob669

Yes, that's the answer I wanted to hear. Cheers M8