do any of you know how easy it is to take the materiel part off the door card so i can re-trim it?

thanks

i'll second this, i've got a classic my99 that needs retrimming

NOT easy.

We did it to some SEAT doorcards, and alls we had to do was change the material part from one card to another.

The material bits were affixed to plastic, and WELDED to the other part of the door card.

We ended up drilling out the plastic welds, and refitting with loads of Sika-Flex.

It worked, but it was a ball-ache to do.

Scoob doorcards are similar, take one off and have a look.....takes about 5 minutes to remove a doorcard.

Alcazar

it will be good if they are on a moulded plastic backing as ive found a company in essex that will cover anything you give them in carbon fiber! thought this would be a little different!

it will be good if they are on a moulded plastic backing as ive found a company in essex that will cover anything you give them in carbon fiber! thought this would be a little different!


I SEEM to think they are, but can't remember whether they can be removed at all, even by drilling out welds.

Take one off, as I said, it really IS a piece of p*ss.

Alcazar

yes might take one off this weekend if i get some time!

how do you think they would look in carbon?

ive removed the materiel off the door card 99 classic and very once u got a end up leaves form under it just needs light sanding same has removing top leather part easy enough once the windowrubbe ris removed lot more form to get rid of tho
has for splitting the door card in two wouldnt d it plastic weils are pain in back side and door cards o thin its very hard get a sew in to get them back together
hope this is of somw help

i wanna do the same to mine they are elahter just wann do the small bit in the middle as i have tvs in my doors wanna trim round them