Hi folks,
Put new coil springs on my 1997 audi a3 1.8 sport,once i put it all back together and looked into the engine bay to tighten the top of the strut i found a small gap between the rubber stop at the top and the actual bodywork. I know on other cars its sits nicly onto of the bodywork part but not sure why this isnt, i have check serveral times that i put all the stuff back on in the correct way and nothing back on upside down. am scared that when i go over a pot-hole or something that it may snap as there is nothing to support it in the gap, hopefully you know what i mean and you guys can help, just ask any questions if you need to know anything.

Thanks