MattW
08 October 2007, 19:27
Mog and all
We have a 2 zone heating system, downstairs stat in hall covers ground floor rooms, plus 2 landings (3 storey). Stat on landing covers bedrooms and bathrooms.
Now obviously the stat on the landing is affected by the warming of the hallway. As a result I'm worried that in winter, bedrooms with closed doors are going to get pretty cold.
I've turned the TRV down on both landing rads to 3, whereas the bedroom ones are on 5 (max).
Also both stats have been replaced for Honeywell CM907 programmable stats so I now have the heating on in the morning upstatis half hour before downstairs.
The CM907 has the ability to have a remote temp sensor, does anyone have experience of this, rather than have a RF stat, I could put one in a bedroom to control the stat. is it possible to run several sensors off a single stat? - edited to say looks like this is hard wired so not really an option for me to do.
We have a 2 zone heating system, downstairs stat in hall covers ground floor rooms, plus 2 landings (3 storey). Stat on landing covers bedrooms and bathrooms.
Now obviously the stat on the landing is affected by the warming of the hallway. As a result I'm worried that in winter, bedrooms with closed doors are going to get pretty cold.
I've turned the TRV down on both landing rads to 3, whereas the bedroom ones are on 5 (max).
Also both stats have been replaced for Honeywell CM907 programmable stats so I now have the heating on in the morning upstatis half hour before downstairs.
The CM907 has the ability to have a remote temp sensor, does anyone have experience of this, rather than have a RF stat, I could put one in a bedroom to control the stat. is it possible to run several sensors off a single stat? - edited to say looks like this is hard wired so not really an option for me to do.