When I arm or disarm the alarm the indicators on the right hand side either dont flash or stay on. The first time it happened I did'nt notice they were stuck on and it flattened my battery and its getting more frequent. I'm guessing its a relay on the alarm, can they be fixed or replaced and were abouts is it so I can try hitting it with a stick.
Thanks

It's on a 51 plate bugeye btw.

Does the same thing happen when you indicate on that side? If so, it will be the flasher relay. Never noticed mine on the scoobs, but most motors I've seen have them in the steering column. You can get plenty of flasher units from most car spares shops.

No mate, indicators work fine, its just when the alarm operates them.

fault with alarm ecu you will have to replace it try the dealer if car is still under warrenty if not have a phone around for local sigma dealer


Adrian

Sigma don't sell these any more, you'd have to get one from a subaru dealer. about £70 IIRC. Single plug connection once you've got into the armoured housing. They turn up on fleabay every so often, but make sure it was manufactured 2002 or later ( theres a 'clock' gauge label on the unit) since earler ones suffered from lockup due to radio interference.
A daewoo dealer might have one since aparently they are used on a Daewoo too, ( dunno which one).Might be worth a try if it turns out a bit cheaper.....

Found an M30 control unit on fleabay, can I just unplug mine and replace it with this.

Found an M30 control unit on fleabay, can I just unplug mine and replace it with this.

Yup, plug and play. You'll need either a working fob for the replacement unit or the PIN code. You can then set your own PIN and programme your own fob. (instuctions to this are on here, do a search for 'sigma sam' or oe alarm sam')

Great stuff, already saved the instruction manual from here, thanks for the help.