ok, hopefullt the last morette question I'll post ;)

well, just got the morettes, and they look really nice. got one question though. there are two wires coming off the relay (for switching full beams?) a blue wire and a grey wire. The instructions indicate that these need to be spliced into the headlight loom.

My question is, what wires on the headlight loom does the brown wire connect to and which one does the blue wire connect to?

bear in mind that my car is a MY94 WRX so the headlight loom might be different (is it?)

thanks for any advice

Getting bit closer here. have looked at the headlamp connector and it's got three wires, black, green and white, so all I need to know is which one do I plug the blue into and which the grey?

what's the worst I could do if I hit the wrong combo? blow a fuse/relay/bulb?

come on, someone must know the answer?

Markus,

Got u r mail m8, but it was 2 dark outside by the time i read it 2 go an check :rolleyes: I`ll check it 4 u 2morrow k ;)

Pete

Pete,
thanks, I look forwared to hearing back from you. I'm just about to go and test fit them now, so it'll probsbly be quite a few hours before I'm ready to wire them up ;)

Pete,
took the plunge and crossed as many apendages as possible and actually followed the instructions, which seemed to be correct, hey presto, working full beams.

must say the car looks really nice now. plus the 'gap' is nowhere near as bad as I though it'd be.

thanks for all your help and advice on this.

Markus,

No prob m8, glad it worked out ;)
Took som pix on Sat 4 the site but they were pretty crap and
didn`t really highlight what i was trying to show :rolleyes:
I`m gonna redo the pix real soon an up them to my site.
Ner mind though as long as u got em working. Glad i could be
of help.

L8r m8
Pete