Just brought secondhand 22mm antiroll bar (rear). what hole should i use for track days the one nearest the bar or the one nearest the end? i have bolted it up on the hole closest to the bar and the end of the arb then catches the track controle arm so i have now put it in the middle hole. The motor is a 95 RA. Thanks Paul

 

Try them all and see which you prefer

Closet to bar is stiffest. Use same hole on each side.

 

same as above but shouldn't catch if you put it on the hardest setting is it deffinately for your model as the arb's are model specific or you could always cut off the soft hole as not many (if any use soft hole)

 

Thanks for the reply guys, ile cut the soft hole off, it catches by 3mm.
Thanks paul