Hi,

I have just bought one of these and was hoping to fit it to my Concept 600 myself. I have a wiring diagram showing which pin on to use on the control module. In the kit there is are a short black wire (ground ?) a short fused red (+ve ?) and a very long green (module ?). There's also the solonoid and a switch (for manual release inside the car I presume) both with 2 unmarked connectors .

The question is does the solonoid need it's own power or just a connection to the module ? There is no relay so I can't see how a 3 way setup would work. But I also have my doubts about whether it's right to take power straight from the module through the solonoid to earth ?

Has anyone fitted one ?

Thanks,

Andy.

You will need to add a relay.
- black wire on solenoid to a good earth
- green wire run from other teminal on solenoid to pin 87 on a relay
- pin 86 and 30 on relay to heavy live fused
- pin 85 connect to the grey/violet from the alarm (ch2 boot release output)
if you want to use that button then connect one terminal to earth and the other to pin 85 on the relay

Hi wannaB4 - YHPM.