Want to mount it in an A-pillar guage but the wires aren't long enough to run under the dash to the ECU :(

Being an electrical illiterate can anyone tell me the best wire/connectors to use to extend the cables?

Preferrable something I can pick up from Maplins :)

Thanks.

Neil

For signals where changes in mV affect readings, the only way to do it properly is to solder IMO

Also, some 16/02 wire (or called 0.5mm) will be good, don't use single strand stuff, like telephone extension wire, for example.

:)

Not sure about the Autometer gauge, but the LamdaLink comes with screened cable due to the small voltages involved.

Thanks for the replys folks - much appreciated.

Decided after all that to with a centre pod !!

Cheers.

Neil