After Simon's great offer on the GGR one, I'm not sure if you guys would want this, but here goes!!

I've got a Prodrive Quickshift from a MY99 car. It's was installed into my car by the pervious owner. Cost £200 from the dealer, any offers??

The throw is about the same as the GGR one, but I've replaced it with an extra short GGR quickshift (even shorter than the one offered by Scoobynet shop!!) I managed to get hold of!!

Cheers
Andy

 

start you off at £50

sure someone will want it more then me tho

robski

 

Robski,

No offence, but I'd want more than £50 for it!

T5NYW/GAZZ,

Not much mechanical knowledge is required!

Basically, take off the gearknob and surrounding trim. Two spanners to undo the old one, a bit of force to pop the old one out.

Position the new one in place, get a lump of wood over it, and then hit it with a hammer. Do up the nuts, replace the trim and the gearknob, and enjoy!!!

More comprehensive details are here:

 

Andy,

1/ How easy is it to fit a Quickshift??
2/ Subaru want £450 to fit one!!
3/ There £100 to buy £350 labour !!
4/ how long would it take to fit one somone with some mechanical knowledge

 

I'm interested
Again how hard is it to fit ?

 

Andy
Is it just a lever like the GGR one ?
How much wear is there on the ball joint connection ?

 

Hi Peter,

Very similar to the GGR one, only it's angled slightly differently. But no catching like some of the guys with their GGR ones!

There seems to be no wear on the ball connection.

Hope this helps
Andy