LOTS OF UPDATES...

I have transplanted a Spec C engine into my Type R, and now have the original drivetrain from the Type R for sale.

The speedo showed 26,852 when dismantled. Since the car was imported from Japan, half of these were km and half were miles, so the drivetrain has probably done 20,000 miles - very low.

Parts included are as follows:
# SOLD STI 6 Engine
# SOLD Intercooler
# SOLD ECU & engine loom.
# SOLD All engine sensors including MAF & airbox
# SOLD Close ratio gearbox with 4.44 front diff & adjustable centre diff
# SOLD Rear diff - 4.44 drop ratio.
# SOLD Front & rear hubs
# SOLD Drive shafts
# SOLD Prop shaft
# SOLD 1 pot rear brake calipers & discs.
# SOLD Dash cluster including centre diff display
# SOLD Centre diff controller and slider control.
# SOLD Rear subframe
# SOLD Wheels
# SOLD Exhaust
# SOLD Springs
# SOLD 2 pot front brake calipers & discs.

STILL FOR SALE

# Front STI alloy wishbones
# STI quick steering rack
# Radiator

YHPM mate.

how much mail me asap....chris...

Please post your offers on the BBS. It saves me posting back to tell everyone what the current highest offer is.
Thanks
Steve

are you selling the brakes separate?

if so how much?

##### I am not willing to split the items at the moment, since it would make the remainder harder to sell. Sale is for all items. #####

However, make me an offer. If I do end up splitting them, I'll let you know.
I'll assume the offer is for 4 discs and 4 calipers.

Sale also includes the full exhaust. Was originally missed off the list at the top.

Steve

If you ever split I will take the box, diff and box ecu off you ! PM me...

Please post your offer. I have been offered 800 for box & diff & diff module.

Stephen
I have a MY99 Uk car running a WRX RA box and diff (non DCCD) - what is needed to convert this transmission to Type R with DCCD? Box? Diff and ECU and nowt else?

Other things you'd need (but this is not a definitive list):
Dash cluster with centre diff display
Loom portion for centre diff
Diff dial.
Check you read hubs match up to the diff, or buy mine.

You need to research this. I'm just selling the parts.

If you take the lot, it is easy. If you start mixing and matching it gets complicated. That is why I am selling a complete drivetrain.

I would be willing to split the engine off, so someone could buy all except engine for example. But if I sell rear diff, I won't be able to sell rear hubs for example.

To start things, let's say 2000 pounds for engine and 1500 pounds for the rest. I'll see where the offers go from there.

I have an offer of 300 for the front discs and calipers, assuming it ends up being split.

Anyone interested in the rear 2 pots & discs ? Would make a nice upgrade for a UK Turbo.

the rear 2pots and discs will only fit on the hubs that match the shafts that match the rear diff

Many STIs have 2 pot rears. But I don't think they all have the big rear diff. So are there two types of 2 pot variants then ?

only the early cars with R180 (large) rear diffs have the 2pot calipers (4door STi's normally have the std sliding caliper & little R160 diff).................
later "new-age" cars have little diff and 2pot set-up, however this is different again...........

alyn - asperformance.com

# Close ratio gearbox with 4.44 front diff & adjustable centre diff
# Rear diff - 4.44 drop ratio.
# Front & rear hubs & wishbones
# Drive shafts
# Prop shaft
# rear brake discs and calipers
# Centre diff controller

I would like to put in an offer for the above items.

Looking to offer around the £1500 mark for it. Any use to you?

Russell

Thanks for the info Alyn. So many variants !

Hi Wuz.
I have an offer of 1500 for those parts without wishbones currently. So you need to better 1500 and factor in the wishbones too.

Cheers

Steve

Cool M8. I don't really need the wishbones so I'll offer £1530 without wishbones.

Russell

Stephen

Thanks for the PM tried to reply but you're over quota!

Thanks for the advice and the offer of notification.

Good luck with the sale!

Ken

BTTT

I would possibly be interested in the full exhaust if you decide to break.

Hi Matt,

Send me your offer.

Cheers

Steve

Hi,

You have PM...

cheers,
Matt

you have pm mate.

sorry mate, you have PM from this login.

Bump.

what is left Steve?

Interested in the intercooler and all pipework (turbo to I/C + I/C to throttle).

let me know how much you want etc.

Won't split IC from engine, sorry.
Matt, check first post for updates and offers.

Where about are you based bud?

How much for MAF inc P&P (if your too far away for me to travel?). Do you know if it will be ok for v5 Sti Type R??

TIA
Omen

is that complete engine with wiring loom etc,

maybe interested