Need to get my car set up after fitting my prodrive springs to my MY 01 rex, but have been asked for the exact settings by the company im planning on using.
Anyone supply me with a printout of what settings( Front and rear Camber and Toe) with standard struts and Prodrive springs.
Spooks

I had prodrive springs fitted to my WRX MY03 aerlire this week.

From The prodrive fitting leaflet.

The settings are;

Tyre pressures

Front 33psi
Rear 31psi

Front Camber -1 deg 15' (1.25 deg)

Front toe total 0.00 deg

Rear toe 0 deg 06' (0.1 deg) per wheel toe in (0 deg 12' (0.2deg) total toe in)

Car drives like a peach with the springs and geometery setup, can recommend this mod to anyone.

Cheers Pockman, dont spose ya know if this is applicable to MY01 do ya, thought there was a difference between the struts on em, I know there is a difference in the spring kit
Spooks

Check the whiteline site they have 2 geometry settings, fast road and race.

Dunno mate, sorry, mine was for a MY03 and quoted from the leaflet that came with the new springset.

Whiteline are a bit different to the Prodrive settings, though. They recommend 1mm toe OUT on the classic, whereas Prodrive go for 1mm toe IN, for example.

Search is working now, so perhaps try there?