Just bought a Apexi AVC-R and am planning on fitting it this friday coming. I am fitting it into a 1995 WRX. Any help, advice or pictures of people that have them fitted etc.. would be of big help as once those ECU wires are cut i got to get it to work. Any help would be much appreciated. Plus when the Apexi is set up, what kind of settings should i be running on my 1995 WRX with the following mods

HKS Sequential Dump Valve
HKS Super Power Flow Induction Kit
HKS Widened Downpipe
HKS Full Hyper Exhaust system

For starters dont cut any ECU wires just cut the sheath back and colder the apexi wires on then heat shrink or tape up

Have you fitted an AVC-R to your car ?

I have..
Do not cut wires! you will probably end up removing it one day and it will leave your loom a bit untidy imo.

As stated, trim off some of the outer casing to the wires and then solder the AVCR wires to them.

Rob

yer i have fitted one to my pulsar. its fairly straight forward. e-mail if you need any help.

Andy