Only £250



75w x 4 - 4 Ohms stereo, 250w x 2 - 4 Ohms bridged, Class A/B 4 Channel Amplifier, 24dB HP/BP/LP variable crossover, crossover configured auxiliary output, remote low pass level control (LPL), dimensions : 16.0L x 10.0W x 2.25H.


High end amplifier, cost is over £400 new.......
It has hardly been used, and in near perfect condition.
I'm selling to partly fund something else for the car.


Buyer pays postage @ £10





Please leave this in the Scotland section as I would prefer to sell locally. Thanks.

[Edited by Scoty - 3/23/2003 7:06:42 AM]

 

Also have Pheonix Gold Distrubution Block for sale for £50.



[Edited by Scoty - 3/23/2003 7:16:46 AM]

 

Might as well stick these up too.



6.5" Component System
• Mid/Woofer: 6 1/2" Diameter (16.51cm) cast aluminium diamond polished baskets with Poly Mica composite cone
• Tweeter: 1" Diameter (2.54cm) silk composite dome with ULV fluid cooled voice coil with neodymium magnets
• Overall Frequency Response 50 Hz - 20 kHz
• Nominal Impedance 4 ohms
• Power Handling (continuous) 25 w
• Power Handling (peak) 150 w
• Efficiency 87 dB
• Crossover LPF/HPF 4200Hz second order Butterworth
• Crossover Dimensions 3-3/8" x 4-3/4" x 1-5/8" (8.57cm x 12.06cm x 4.13cm)
• Voice Coil Diameter: Driver 1-1/2" (3.81cm)
• Voice Coil Diameter: Tweeter 1" (2.54cm)

Run these in the front doors, and hook them up to the Ti500 amp, and

Please note, I no longer have the front silver grill's for these speakers

[Edited by Scoty - 3/23/2003 7:49:20 AM]

 

AARRGGHH ! I just went and bought a pair of 6 1/2 infinitys the other day !!!
How much you needing for them Scoty?

 

It is OK Scoty I found your other post in "for sale" so now I know

 

Ahhh, thought I was going to be heading to the B&O Centre tomorrow

I have never heard better staging and clear reproduction from car audio components. If you want very high quality sound, these are for you. You do need some considerable power, though.
So why not buy the amp too....

 

All sold