View Full Version : Adjusting Clifford Sensitivity


NotoriousREV
16 January 2003, 17:06
OK, I *think* I have a Concept 300 on my Impreza.

The bloody thing has gone off every night this week despite having sat on my drive for 6 months and never making a sound.

It goes off and as soon as I reset it it gives 2 chirps and almost instantly goes off again, then I reset it again and it gives 4 chirps and doesn't go off again until the next night.

What can I do quickly and easily to stop it pissing me and my neighbours off (apart from disarming it completely)?

Thanks in advance

doctor CLIFFORD
16 January 2003, 22:15
After the alarm has sounded turn it off and start the engine then count the number of flashes on the Clifford LED this will tell you what caused the trigger. The table for what flash means what is in your manual.

NotoriousREV
17 January 2003, 00:23
Unfortunately, I don't have a manual.

I think I'll take it to my local Clifford dealer at the weekend and have them sort it out.

NotoriousREV
19 January 2003, 18:40
OK, didn't get chance to take the car to a Clifford dealer, but the flash sequence I'm getting is 4 sets of 5 flashes. What does this tell me?

Thanks

GaryM
19 January 2003, 22:30
If the error codes are the same across all the range then 5 flashes is your boot switch.

doctor CLIFFORD
19 January 2003, 22:32
http://www.clifford.com/guides/ogs/concept300uk_owners.pdf
If you down load this its the manual for the concept 300

Cheers Doc.

NotoriousREV
19 January 2003, 23:15
Doc, you are a star, mate. Fantastic. Looks like my bonnet sensor needs adjusting. My neighbours thank you, and so do I! :)


LinkBacks Enabled by vBSEO 3.2.0 © 2008, Crawlability, Inc.