Prodrive/Powerstation Geometry Settings
Thread Starter
Joined: Feb 2001
Posts: 4,124
Likes: 13
From: Kent in a 396bhp Scoob/Now SOLD!
Antyone know what they are?
Ive got the original receipt I was given with the car when the Power Station mod was done, showing before and after.
Id like to get them rechecked as my car is pulling right slightly.
Its just difficult, not know what you are aiming for.
Scooby Regular
Joined: Dec 2001
Posts: 6,963
Likes: 0
From: Just far enough from sunny Liverpool
Not sure about Prodrive or Powerstation, but my tarmac settings are as follows.
Front and Rear;
As much negative camber as possible but make sure both sides exactly the same.
(Should be able to get to 1 min 25 or 30)
Front .8 total toe in- ie .4 each side
Rear .2 total toe in- .ie .1 each side
Hope this helps (works extremely well for me)
simon
Front and Rear;
As much negative camber as possible but make sure both sides exactly the same.
(Should be able to get to 1 min 25 or 30)
Front .8 total toe in- ie .4 each side
Rear .2 total toe in- .ie .1 each side
Hope this helps (works extremely well for me)
simon
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
